On computers and routers, 12VPX NEO runs as a background service that you can control in three ways: the desktop app, the web interface in a browser, and the command line. This page explains the web interface and how to control 12VPX NEO on another device, such as your router.
Contents
- Open the web interface
- Control a router or another computer from the desktop app
- Let other devices control this computer
- Keep it on your home network
- Remote control, Router Mode and LAN Proxy Access
Open the web interface
| Where 12VPX NEO runs | Open | Sign in |
|---|---|---|
| This computer | http://127.0.0.1:9847, or run vpx open |
No sign-in needed |
| Your OpenWrt router | http://192.168.1.1:9847, using your router's address, or VPN → 12VPX NEO in the router's LuCI menu |
root and the router's own password |
| Another computer | http:// plus that computer's network address and :9847, after you turn on remote control there |
The username and password you set there |
127.0.0.1 always means the device you are typing it on. On your phone it reaches your phone, not your router or computer.
The web interface has the same screens as the desktop app: Dashboard, Servers, Settings, Support and Logs. Closing the browser tab doesn't disconnect; use Disconnect.
The web interface only controls 12VPX NEO. Opening it does not send the browser's own traffic through the VPX service.
Control a router or another computer from the desktop app
- Open Settings → Remote Control → Control Another Device.
- Enter the device's address and port, for example
192.168.1.1:9847. - Enter its username and password. For an OpenWrt router that is
rootand the router's own password. - Choose Connect. The app now says Controlling the VPN at and the device's address, and everything you do applies to that device: connecting, servers, settings and logs.
- Choose Use this computer instead to go back.
Controlling your router does not send your computer's traffic through it. Your computer's traffic goes through the router's connection only when your computer uses the router's network and Router Mode is on.
If the app says No response from the address, check the address and that remote control is turned on there. If it says the username or password was rejected, check them: these are not your 12VPX website login.
Let other devices control this computer
- Open Settings → Remote Control → Enable Remote Control.
- Choose the network the other devices can reach this computer on. Disabled (localhost only) turns remote control off.
- Set a username and password.
- Choose Save & Restart. The service restarts, and the app shows the address it listens on, such as Listening on 192.168.1.20:9847.
On an OpenWrt router you don't need to do this: the web interface is already available on your network, with the router's own login.
If you forget the password, run vpx reset-password on that computer. That turns remote control off until you set a new password.
Keep it on your home network
Remote control uses plain HTTP, like the settings page of most home routers. That is fine on a network you trust, such as your home network. Don't turn it on on public Wi-Fi, and never make port 9847 reachable from the internet.
Remote control, Router Mode and LAN Proxy Access
These three settings all involve other devices, but do different things:
| Setting | What it does |
|---|---|
| Remote Control | Lets another device change this device's 12VPX NEO settings and connection. It carries no traffic. |
| Router Mode | Sends the traffic of the devices on your network through 12VPX NEO, on a router or Linux gateway. |
| LAN Proxy Access | Lets devices you set up with a proxy use this computer's connection to the VPX service. |